Edirol R-4Pro Manual de usuario descargar pdf (Pagina 86)

Appendix

Setting the internal timecode start time

fig.recording-1.eps

Press the [SYSTEM] button on the R-4 Pro.

The display shows the System Menu screen.

fig.time-code-1.eps

Use the [CURSOR] button to select 6 Timecode, and press

the

[ENTER] button.

The Timecode screen is shown.

fig.time-code-2.eps

Use the [CURSOR] button to select 2 Set Int TC, and

press the [ENTER] button.

The display shows the Set Int TC screen.

fig.time-code-set-int.eps

Use the [CURSOR] button to select the input location,

and then set the start time with the [SCRUB/VALUE]

dial.

* H:M:S:F: indicates Hours: Minutes: Seconds: Frames, respectively.

The F value differs according to the Frame Rate value in the Timecode

Setup.

* To cancel the settings, press the [EXIT] button.

fig.time-code-4.eps

Press the [ENTER] button.

After the screen shown in the figure to the right is displayed, the

set time is shown as CURRENT, and the timecode begins.

After setting the value, press the [EXIT] button.

The display returns to the Timecode screen.

Return to the Main screen by pressing the [EXIT] button again.

Setting the start time

R-4_e_new.book 86 ページ２００６年１１月２０日　月曜日　午後１時９分

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 107 108

Sin comentarios

Edirol R-4Pro Manual de usuario Pagina 86